Joint Push Pull Fehlermeldung

[stadtbahnzug]

Moin Forum,

ich erhalte beim Extrudieren mit Joint Push Pull folgende Fehlermeldung:

Code:

An error occured in Joint Push Pull Error in generation of the geometry JointPushPullGeometry.rb 1107 block in geometry_coplanar_edges_overhang  JointPushPullGeometry.rb 1105 each  JointPushPullGeometry.rb 1105 each_with_index  JointPushPullGeometry.rb 1105 geometry_coplanar_edges_overhang  JointPushPullGeometry.rb 354 block in geometry_robot_erase_coplanar_edges  JointPushPullGeometry.rb 352 each  JointPushPullGeometry.rb 352 geometry_robot_erase_coplanar_edges  JointPushPullGeometry.rb 214 robot_call_action  JointPushPullGeometry.rb 177 geometry_robot_exec  JointPushPullGeometry.rb 160 geometry_robot  JointPushPullGeometry.rb 75 block in geometry_execute  Lib6Operation.rb 317 call Lib6Operation.rb 317 step_geometry  Lib6Operation.rb 358 start_execution  JointPushPullGeometry.rb 75 geometry_execute  JointPushPullTool.rb 1138 execute_validate  JointPushPullTool.rb 1329 onReturn

Kann jemand erklären, was da schief geht und wie ich es ggf. doch noch hinbekomme.

Danke und Gruss

stadtbahnzug

Oliver